PLASTICON SBR BOND AR 35 is a single-component, SBR-based polymer, consisting of polymer and liquid additives. It can be used in combination with cement as a waterproof coating for terraces, balconies, and roof slabs. It develops an excellent bond with concrete & all building materials. PLASTICON SBR BOND AR 35  can also be used for concrete repair as primer or PMM.  

PLASTICON SBR BOND AR 35  is an SBR-based polymer used for making cement-based waterproofing slurry that is flexible and can be used as a coating for the control of efflorescence. PLASTICON SBR BOND AR 35  can be used as a bonding agent also.

Waterproofing of toilets, terraces, roofs, Chajjas, etc. Suitable for general concrete repairs. It gives excellent bond strength. It can be used for the protection of concrete against corrosion, salt attack, etc.

As a Bonding agent: 1 Kg. SBR BOND AR 35  mixed with 2 kg neat cement covers approx. 2.0-2.5 sqm area in 2 coats depending upon the surface.

As a waterproof coating: 1 Kg. SBR BOND AR 35  mixed with 2 Ltr. Water and 2.5 Kg neat cement covers approx. 2.0-2.5 sqm area in 2 coats depending upon the surface.vy

PLASTICON SBR BOND AR 35  is available in 5 kg. & 25 kg.

1. Used as a structural repair
2. Used as a polymer modified mortar
3. Used in old to new concrete binding.
4. Used before brick back coba as a primer coating.
5. Used as an admixture in concrete.
6. Used for heavy duty waterproofing.

• Waterproof slurry coat
• Bonding agent for plastering and masonry work
• To resist capillary movement in render and mortar

• Clean the surface below application to remove any loose particles or laitance
• Saturate it thoroughly and remove excess water before application
All tests done under standard laboratory conditions. All above are volumetric mixing rations for detailed directions for use, refer datasheet.

PLASTICON SBR LATEX is available in 5 kg. & 25 kg.

Surface preparation and application techniques The substrate to receive Unibond shall be free of dust, all protruding materials like all, chicken mesh mold Oil, etc. Open the contents of Unibond and stir the contents thoroughly to allow for aggregates to remain in suspension. Dip the paintbrush in Unibond and apply evenly to the substrate. Apply Gypsum Plaster within 10 days of application of Unibond. However, the application could commence as early as 60 minutes after application for thin renders, and for higher thickness wait for 24 hrs and beyond.

PLASTICON UNIBOND is a product based on water-dispersible complex polymers and graded aggregates. Application of this product on plaster or concrete surfaces allows for minimal surface preparation thereby saving on cost and labor.

As a bonding agent for cement screeds, render, and plaster on concrete. As a bonding agent for Gypsum plaster on concrete or plaster surface.

It is ready to apply the product. It contains graded aggregates that create a mechanical key. Renderings can be applied within 60 minutes of the application of Plasticon Unibond and up to a maximum time of 10 days after the application of the Unibond coating.

The coverage of the product shall vary between 3.5 to 4.5 m²/kg and the same will depend upon the surface being applied.

One year when stored as recommended in the original packing, In cool and dry conditions.

Always shake the contents wall before use

UNIBOND is available in 5 kg. & 25 kg.